Interfaces
Page 450 7750 SR Interface Configuration Guide
Context config>port>multilink-bundle
Description This command configures a working bundle that is part of this BPGrp.
Parameters bundle-id — Specifies the working multilink bundle in the bundle protection group. The command syntax
must be configured as follows:
Syntax: bundle-type-slot/mda.bundle-num
bundle-PPP or IMA-slot/mda.bundle-num (Creates an MLPPP or IMA bundle.)
bundle: keyword
slot: IOM/MDA slot numbers
bundle-num: 1 — 256
For example:
router1>config>port>ml-bundle> working-bundle bundle-ima-1/1.1
yellow-differential-delay
Syntax yellow-differential-delay yellow-diff-delay
no yellow-differential-delay
Context config>port>multilink-bundle
Description This command sets the yellow warning threshold for the differential delay for members within a multilink
bundle. If circuit’s delay exceeds the yellow-differential delay value, a log message and SNMP trap is sent.
This command is only valid for MLPPP bundles. The differential delay is calculated as the round-trip differ-
ential delay for MLPPP bundles.
The no form of this command removes the yellow-differential-delay.
The no form of this command removes the yellow-differential-delay.
Default None
Parameters yellow-diff-delay — Specify the maximum yellow differential delay threshold value.
Values 1— 25 milliseconds
ima
Syntax ima
Context config>port>multilink-bundle
Description This command enables the context to configure parameters for an Inverse Multiplexing over ATM (IMA)
group. An IMA group is a collection of physical links bundled together and assigned to an ATM interface.
IMA enables a high-speed channel that is composed of ATM cells to be transported as a number of lower-
speed circuits. Then they are reassembled as the original high-speed ATM channel. This command is only
valid for IMA bundles.
To Next Page
Loading...
