Alcatel-Lucent 7750 - Page 465

Interface Configuration
7750 SR Interface Configuration Guide Page 465
The no form of this command disables the sending of echo requests.
Default keepalive 10 dropcount 3
Parameters time-interval — The time interval, in seconds, that echo requests are issued.
Values 1 — 60
Default 10
dropcount count — The number of keepalive messages that can be missed before the line is brought down.
Values 1— 255
Default 3
report-alarm
Syntax [no] report-alarm {pais | plop | prdi | pplm | prei}
Context config>port>sonet-sdh>path
Description This command enables logging of SONET (SDH) path alarms for a SONET-SDH port. Only path alarms can
be configured in the channel context.
The no form of this command disables logging of the specified alarms.
Parameters pais — Reports path alarm indication signal errors. When configured, pais alarms are raised and cleared.
Default pais alarms are not issued
plop — Reports path loss of pointer (per tributary) errors. When configured, plop traps are raised but not
cleared.
Default plop traps are issued
prdi — Reports path remote defect indication errors. When configured, prdi alarms are raised and cleared.
Default prdi alarms are not issued
pplm — Reports a path payload mismatch, as a result the channel will be brought down. When configured,
pplm traps are raised but not cleared.
Default pplm traps are issued
prei — Reports a path error condition raised by the remote as a result of b3 errors received from this node.
When configured, prei traps are raised but not cleared
Default prei traps are not issued
scramble
Syntax [no] scramble
Context config>port>sonet-sdh>path