Alcatel-Lucent 7750 - Page 492

Interfaces
Page 492 7750 SR Interface Configuration Guide
Description This command defines the data pattern to be transmitted when the circuit emulation service is not opera-
tional or temporarily experiences under-run conditions. This command is only valid for cesopsn and
cesopsn-cas circuit emulation services. It is blocked with a warning for unstructured (satop) circuit emula-
tion services.
Default all-ones
Parameters all-ones — Defines the 8 bit value to be transmitted as 11111111.
pattern — Transmits a user-defined pattern.
idle-signal-fill
Syntax idle-signal-fill {all-ones}
idle-signal-fill pattern pattern
no idle-signal-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the signaling pattern to be transmitted when the circuit emulation service is not oper-
ational or temporarily experiences under-run conditions. This command is only valid for cesopsn-cas circuit
emulation services. It is blocked with a warning for unstructured (satop) and basic cesopsn circuit emulation
services.
Default all-ones
Parameters all-ones — Defines the 8 bit value to be transmitted as 11111111.
pattern — Transmits a user-defined pattern.
insert-single-bit-error
Syntax insert-single-bit-error
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command inserts a single bit error for the BERT test.
Default no bit-error-insertion
invert-data
Syntax [no] invert-data
Context config>port>tdm>ds1
config>port>tdm>e1