Interface Configuration
7750 SR Interface Configuration Guide Page 495
The no form of this command disables transmission of the specified message or all messages.
Default no mdl-transmit
Parameters path — Specify the MDL path message.
idle-signal — Specify the MDL idle signal message.
test-signal — Specify the MDL test signal message.
remote-loop-respond
Syntax [no] remote-loop-respond
Context config>port>tdm>ds1
Description When enabled, the channel responds to requests for remote loopbacks.
Default no remote-loop-respond — The port will not respond.
report-alarm
Syntax [no] report-alarm [ais] [los] [oof] [rai] [looped] [ber-sd] [ber-sf]
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command enables logging of DS-1/DS-3 or E-1/E-3 alarms for DS-1/DS-3 or E-1/E-3 ports or chan-
nels.
The no form of this command disables logging of the specified alarms.
Parameters ais — Reports alarm indication signal errors. When configured, ais alarms are not raised and cleared.
Default ais alarms are issued
los — Reports loss of signal errors. When configured, los traps are not raised and cleared.
Default los traps are issued.
oof — Reports out-of-frame errors. When configured, oof alarms are not raised and cleared.
Default oof alarms are not issued.
rai — Reports resource availability indicator events. When configured, rai events are not raised and
cleared.
Default rai alarms are not issued
looped — Reports looped packets errors.
looped alarms are not issuedlof — Reports loss of frame errors. When configured, lof traps are not raised
and cleared.
Default lof traps are issued
To Next Page
Loading...
