Alcatel-Lucent 7750 - Page 501

Interface Configuration
7750 SR Interface Configuration Guide Page 501
disable-soft-reset-extension
Syntax [no] disable-soft-rest-extension
Context config>lag>bfd
Description This command enables the BFD context and enables BFD over LAG links. Additional parameter configura-
tion is required to make BFD over LAG links operational. Normally, BFD session timers are automatically
extended during soft-reset operation on the IOMs and IMMs to avoid BFD sessions timing out and causing
protocol events. However, in some cases this behavior is not desired as it could delay fast re-route transitions
if they are in place. The optional disable-soft-reset-extension keyword allows this behavior to be disabled so
that the BFD timers are not automatically extended.
Parameters disable-soft-reset-extension — Disables the automatic extension of BFD timers during an IOM/IMM soft-
reset.
per-fp-sap-instance
Syntax [no] per-fp-sap-instance
Context config>lag>access
Description This command enables optimized SAP instance allocation on a LAG. When enabled, SAP instance is allo-
cated per each FP the LAG links exits on instead of per each LAG port.
The no form of this command disables optimized SAP instance allocation.
Default no per-fp-sap-instance
per-fp-egr-queuing
Syntax [no] per-fp-egr-queuing
Context config>lag
Description This command specifies whether a more efficient method of queue allocation for LAG SAPs should be uti-
lized.
The no form of the command disables the method of queue allocation for LAG SAPs.
per-fp-ing-queuing
Syntax [no] per-fp-ing-queuing
Context config>lag
Description This command specifies whether a more efficient method of queue allocation for LAG SAPs should be uti-
lized.