Interface Configuration
7750 SR Interface Configuration Guide Page 525
control-mep
Syntax [no] control-mep
Context config>eth-tunnel>path>eth-cfm>mep
Description This command enables the usage of the CC state by the Ethernet tunnel manager for consideration in the
protection algorithm. The use of control-mep command is recommended if fast failure detection is required,
especially when Link Layer OAM does not provide the required detection time.
The no form of this command disables the use of the CC state by the Ethernet tunnel manager\.
Default no control-mep
shutdown
Syntax [no] shutdown
Context config>eth-tunnel>path>eth-cfm>mep
Description This command administratively enables/disables the MEP.
The no form of this command enables the MEP.
Default shutdown
shutdown
Syntax [no] shutdown
Context config>eth-tunnel>path
config>eth-tunnel
Description This command administratively enables/disables the path.
The no form of this command enables the path.
To Next Page
Loading...
