Alcatel-Lucent 7750 - Page 531

Interface Configuration
7750 SR Interface Configuration Guide Page 531
DefXconCCM
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
config>router>if>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of the command reverts to the MAC address of the MEP back to the default, that of the port,
since this is SAP based.
Default no mac-address
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP. Using
the all zeros address is equivalent to the no form of this command.
one-way-delay-threshold
Syntax one-way-delay-threshold seconds
Context config>eth-tunnel>path>eth-cfm>mep
Description This command enables one way delay threshold time limit.
Default 3 seconds
Parameters priority — Specifies the value for the threshold.
Values 0 — 600
facility-fault
Syntax [no] facility-fault
Context config>lag>eth-cfm>mep
config>port>ethernet>eth-cfm>mep