Interfaces
Page 540 7750 SR Interface Configuration Guide
passive-mode
Syntax [no] passive-mode
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command configures the passive mode behavior for the MC-EP protocol. When in passive mode the
MC-EP pair will be dormant until two of the pseudowires in a MC-EP will be signaled as active by the
remote PEs, being assumed that the remote pair is configured with regular MC-EP. As soon as more than one
pseudowire is active, dormant MC-EP pair will activate. It will use the regular exchange to select the best
pseudowire between the active ones and it will block the Rx and Tx directions of the other pseudowires.
The no form of this command will disable the passive mode behavior.
Default no passive-mode
system-priority
Syntax system-priority value
no system-priority
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command allows the operator to set the system priority. The peer configured with the highest value is
chosen to be the Master. If system-priority are equal then the one with the lowest system-id (chassis MAC
address) is chosen as the Master.
The no form of this command sets the system priority to default
Default 0
Parameters value — Specifies the priority assigned to the local MC-EP peer.
Values 1— 255
To Next Page
Loading...
