Alcatel-Lucent 7750 - Page 545

Interface Configuration
7750 SR Interface Configuration Guide Page 545
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Description This command configures a range of encapsulation values.
Parameters Values encap-range
Specifies a range of encapsulation values on a port to be synchronized with a multi-chassis peer.
Values Dot1Q start-vlan-end-vlan
QinQ Q1.start-vlan-Q1.end-vlan
sync-tag sync-tag — Specifies a synchronization tag up to 32 characters in length to be used while synchro-
nizing this encapsulation value range with the multi-chassis peer.
srrp
Syntax [no] srrp
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether subscriber routed redundancy protocol (SRRP) information should be syn-
chronized with the multi-chassis peer.
Default no srrp
sub-mgmt
Syntax [no] sub-mgmt
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether subscriber management information should be synchronized with the
multi-chassis peer.
Default no sub-mgmt