Alcatel-Lucent 7750 - Page 591

Interface Configuration
7750 SR Interface Configuration Guide Page 591
A sfm3-12 sfm3-12 up up/standby
B sfm3-12 sfm3-12 up up/active
===============================================================================
A:ALU-48#
A:ALA-48# show card 1
===============================================================================
Card Summary
===============================================================================
Slot Provisioned Equipped Admin Operational
Card-type Card-type State State
-------------------------------------------------------------------------------
1 iom-xp iom-xp up up
A cfm-xp cfm-xp up up/active
B cfm-xp up down/standby
===============================================================================
A:ALA-48#
A:ALA-50# show card 1
===============================================================================
Card Summary
===============================================================================
Slot Provisioned Equipped Admin Operational
Card-type Card-type State State
-------------------------------------------------------------------------------
1 iom-c4-xp iom-c4-xp up up
A cfm-c4-xp cfm-c4-xp up up/active
B cfm-c4-xp up down/standby
===============================================================================
A:ALA-50#
Show Card State Output — The following table describes show card state output fields.
Sample Output
Label Description
Slot/MDA
The slot number of the card in the chassis.
Provisioned Type
The card type that is configured for the slot.
Equipped Type
The card type that is actually populated in the slot.
Admin State
Up — The card is administratively up.
Down — The card is administratively down.
Operational
State
Up — The card is operationally up.
provisioned — There is no card in the slot but it has been pre-
configured.
Num Ports
The number of ports available on the MDA.
Num MDA
The number of MDAs installed.
Comments
Indicates whether the SF/CPM is the active or standby.