Alcatel-Lucent 7750 - Page 614

Interfaces
Page 614 7750 SR Interface Configuration Guide
pools
Syntax pools mda-id [/port] [access-app [pool-name | service service-id]] | queue-group queue-group-
name]]
pools mda-id [/port] [network-app [pool-name |queue-group queue-group-name]]
pools mda-id [/port] [direction [pool-name |service service-id| queue-group queue-group-name]]
Context show
Description This command displays pool information.
Parameters mda-id[/port] — Displays the pool information of the specified MDA and port.
access-app pool-name — Displays the pool information of the specified QoS policy.
Values access-ingress, access-egress
service service-id — Displays pool information for the specified service.
Values 1 — 2147483647
queue-group queue-group-name — Display information for the specified queue group.
direction — Specifies to display information for the ingress or egress direction.
Values ingress, egress
Output Show Pool Output — The following table describes show pool output fields.
Label Description
Type
Specifies the pool type.
ID
Specifies the card/mda or card/MDA/port designation.
Application/Type
Specifies the nature of usage the pool would be used for. The pools could be
used for access or network traffic at either ingress or egress.
Pool Name
Specifies the name of the pool being used.
Resv CBS
Specifies the percentage of pool size reserved for CBS.
Utilization
Specifies the type of the slope policy.
State
The administrative status of the port.
Start-Avg
Specifies the percentage of the buffer utilized after which the drop
probability starts to rise above 0.
Max-Avg
Specifies the percentage of the buffer utilized after which the drop
probability is 100 percent. This implies that all packets beyond this point
will be dropped.
Time Avg Factor
Specifies the time average factor the weighting between the previous shared
buffer average utilization result and the new shared buffer utilization in
determining the new shared buffer average utilization.