Interface Configuration
7750 SR Interface Configuration Guide Page 629
Current APS Status : OK No. of Switchovers : 0
Last Switchover : None Switchover seconds : 0
Signal Degrade Cnt : 1 Signal Failure Cnt : 1
Last Switch Cmd : No Cmd Last Exercise Result : Unknown
Tx L-AIS : None
-------------------------------------------------------------------------------
APS Protection Circuit - 1/9/5
-------------------------------------------------------------------------------
Admin Status : Up Oper Status : Up
Current APS Status : OK No. of Switchovers : 0
Last Switchover : None Switchover seconds : 0
Signal Degrade Cnt : 1 Signal Failure Cnt : 1
Last Switch Cmd : No Cmd Last Exercise Result : Unknown
Tx L-AIS : None
===============================================================================
*A:Dut-A#
show aps on protect MC-APS node:
B:Dut-E# show aps
==================================================================================
APS Group Info
==================================================================================
Interface Admin Oper MC-Ctl Work Prot Active Tx/Rx
State State State Circuit Circuit Circuit K1 Byte
----------------------------------------------------------------------------------
aps-20 Up Up N/A 3/1/1 3/1/2 3/1/1 PC-Tx: No-Req
==================================================================================
B:Dut-E#
B:Dut-E# show aps aps-30 detail
===============================================================================
APS Group: aps-30
===============================================================================
Description : APS Group
Group Id : 30 Active Circuit : N/A
Admin Status : Up Oper Status : Up
Working Circuit : N/A Protection Circuit : 2/2/2
Switching-mode : Bi-directional Switching-arch : 1+1
Revertive-mode : Non-revertive Revert-time (min) :
Rx K1/K2 byte : 0x00/0x05 (No-Req on Protect)
Tx K1/K2 byte : 0x00/0x05 (No-Req on Protect)
Current APS Status : OK
Multi-Chassis APS : Yes
Neighbor : 13.1.1.1
Control link state : Up
Advertise Interval : 1000 msec Hold time : 3000 msec
Mode mismatch Cnt : 0 Channel mismatch Cnt : 0
PSB failure Cnt : 0 FEPL failure Cnt : 1
-------------------------------------------------------------------------------
APS Working Circuit - Neighbor
-------------------------------------------------------------------------------
Admin Status : N/A Oper Status : N/A
Current APS Status : OK No. of Switchovers : 0
Last Switchover : None Switchover seconds : 0
Signal Degrade Cnt : 0 Signal Failure Cnt : 0
To Next Page
Loading...
