Alcatel-Lucent 7750 - Page 652

Interfaces
Page 652 7750 SR Interface Configuration Guide
Sample Output
A:ALA-251# show port 1/2/1 detail
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Interface : 1/2/1 Oper Speed : 0 mbps
Link-level : Ethernet Config Speed : 100 mbps
Admin State : up Oper Duplex : N/A
Oper State : down Config Duplex : full
Physical Link : No MTU : 1514
Single Fiber Mode : No Clock Mode :synchronous
IfIndex : 37781504 Hold time up : 0 seconds
Last State Change : 01/03/2008 15:17:00 Hold time down : 0 seconds
Last Cleared Time : 01/03/2008 15:17:01
Phys State Chng Cnt: Last Cleared Time : N/A DDM Events :
Enabled
Phys State Chng Cnt: 3Configured Mode : network Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Net. Egr. Queue Pol: default
Egr. Sched. Pol : n/a
Auto-negotiate : false MDI/MDX : unknown
Accounting Policy : None Collect-stats : Disabled
Egress Rate : Default Ingress Rate : Default
Load-balance-algo : default LACP Tunnel : Disabled
Unknown Proto
Discards Input/
Output
For packet-oriented interfaces, the number of packets received
through the interface which were discarded because of an unknown or
unsupported protocol. For character-oriented or fixed-length
interfaces that support protocol multiplexing the number of
transmission units received via the interface which were discarded
because of an unknown or unsupported protocol. For any interface
that does not support protocol multiplexing, this counter will always
be 0. For ATM, this field displays cells discarded on an invalid vpi/
vci. Unknown proto discards do not show up in the packet counts.
Errors
For ATM, this field displays the number of cells discarded due to
uncorrectable HEC errors. Errors do not show up in the raw cell
counts.
LLF Admin State
Displays the Link Loss Forwarding administrative state.
LLF Oper State
Displays the Link Loss Forwarding operational state.
Rx S1 Byte
Displays the received S1 byte and its decoded QL value.
Tx S1 Byte
Displays the transmitted S1 byte and its decoded QL value.
Tx DUS/DNU
Displays whether the QL value is forcibly set to QL-DUS/QL-DNU.
Label Description (Continued)