Interfaces
Page 706 7750 SR Interface Configuration Guide
mc-ring global-statistics
Context show>redundancy>multi-chassis
Description This command displays multi-chassis ring information.
Parameters ip-address — Specifies the address of the multi-chassis peer to display.
ring sync-tag — Specifies a synchronization tag to be displayed that was used while synchronizing this port
with the multi-chassis peer.
node ring-node-name — Specifies a ring-node name.
global-statistics — Displays global statistics for the multi-chassis ring.
detail — Displays detailed peer information for the multi-chassis ring.
MC-Ring Peer IP-address Ring Output Fields
Output Show mc-ring peer ip-address ring Output — The following table describes mc-ring peer ip-address
ring output fields.
Label Description
Sync Tag Displays the synchronization tag that was used while synchronizing this
port with the multi-chassis peer.
Oper State noPeer — The peer has no corresponding ring configured.
connected — The inband control connection with the peer is
operational.
broken — The inband control connection with the peer has timed out.
conflict — The inband control connection with the peer has timed out
but the physical connection is still OK; the failure of the inband signaling
connection is caused by a misconfiguration. For example, a conflict
between the configuration of this system and its peer, or a misconfiguration
on one of the ring access node systems.
testingRing — The inband control connection with the peer is being
set up. Waiting for result.
waitingForPeer — Verifying if this ring is configured on the peer.
configErr — The ring is administratively up, but a configuration error
prevents it from operating properly.
halfBroken — The inband control connection indicates that the ring is
broken in one direction (towards the peer).
localBroken — The inband control connection with the peer is known
to be broken due to local failure or local administrive action.
shutdown — The ring is shutdown.
To Next Page
Loading...
