Interface Configuration
7750 SR Interface Configuration Guide Page 749
queue-group
Syntax queue-group queue-group-name egress network instance instance-id [policer policer-id]
[egress-queue egress-queue-id] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command enables queue-group monitoring for the specified parameters.
port
Syntax atm [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>port
Description This command enables ATM port traffic monitoring.
Parameters interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Sample Output
A:ALA-49# monitor port 9/1/1 atm interval 3 repeat 2 absolute
===============================================================================
Monitor ATM statistics for Port 9/1/1
===============================================================================
Input Output
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
Octets 0 0
Cells 0 0
Unknown VPI/VCI Cells 0
-------------------------------------------------------------------------------
At time t = 3 sec (Mode: Absolute)
-------------------------------------------------------------------------------
Octets 0 0
Cells 0 0
Unknown VPI/VCI Cells 0
-------------------------------------------------------------------------------