8.2.8 Connect the device to the deskphone using Bluetooth® (compatible Bluetooth® deskphone)
• Switch on the 8105s EGO.
• Put the device in detectable mode: hold the Bluetooth® button down for two seconds on the 8105s EGO:
. The following icon is displayed on the screen of the device: .
• From your deskphone, pairing the 8105s EGO:
o Using the left-right navigator keys, select the settings menu.
o Phone Bluetooth® Add device
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be displayed.
o Select the relevant equipment: “Konftel Ego”
o Add
• The 8105s EGO is successfully paired. The following icon is displayed a couple of seconds on the 8105s
EGO screen: . It is detected as a Bluetooth® headset. The following icons are displayed on the status
bar of your deskphone: , .
To remove the device, follow instructions described in the section: “Removing a Bluetooth® accessory (headset,
handset, etc.)”.
8.2.9 Using the 8105s EGO
The 8105s EGO is used as an external hands-free device.
• When you receive a call, the device is ringing and an icon is displayed on the screen: / . The leds
are flashing green.
• Answer the call.
• Activate/deactivate the mute feature during a conversation. The mute icon is displayed on the 8105s
EGO if activated:
• Use the volume buttons of the deskphone or 8105s EGO to turn the volume up or down.
• End the call. You can end the call from the deskphone.
You can resume the call with the handset at any time by unhooking it or by switching between audio mode (
).
To Next Page
Loading...
