Alcatel-Lucent 8232 DECT - 2 Getting started; 2.1 Installing the battery in the telephone

8232 DECT Handset
8AL90861USACed01
11 /56
2 Getting started
In order to have a fully operational 8232 DECT Handset, make sure that you have the following items: the battery, the
AC/DC adapter, the power supply and the USB cable.
2.1 Installing the battery in the telephone
2.1.1 Installing the battery in the telephone
If the belt clip is installed, you must lift it up and maintain it in this position during
the battery installation or replacement. You are advised to proceed with the belt
clip lifted rather than turned.
You can also turn the belt clip counterclockwise.
Lift up the cover.
Position the battery 'connectors ' side as shown in the drawing (A). Terminate the
installation of the battery in its compartment by pressing as shown in the drawing
(B).
Replace the cover.
2.1.2 Removing the battery from the telephone
If the belt clip is installed, you must lift it up and maintain it in this position during
the battery installation or replacement.
You can also turn the belt clip counterclockwise.
Lift up the cover.