8AL90861USACed01
11 Declaration of compliance
Marking:
This equipment uses the DECT harmonized frequency spectrum (1880Mhz-1900Mhz).
This equipment is in compliance with the essential requirements of R&TTE Directive 1999/5/EC and with Directive
2011/65/UE (ROHS).
The Declaration of Conformity may be obtained from: 32, avenue Kléber - 92700 Colombes – France
Contact: ebg_global_supportcenter@al-enterprise.com
USA and Canada
Handset: this device complies with Part 15-D of the FCC Rules and with RSS-213 of Industry Canada (). (FCC ID:
T7HCT8121 IC: 4979B-CT8121). This device complies with Part 68 of the FCC Rules and with IC CS-03 Part V of
Industry Canada. The ACTA registration number is: T7HW4NANCT8121.
Chargers: this device complies with Part 15-B of the FCC Rules and with ICES-003 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Exposure to Radio Frequency Signals:
This device has been designed and manufactured not to exceed the SAR (Specific Absorption Rate) radio frequency
power transmission limits established by the different countries concerned. The SAR value measured is equal to 0.102
W/kg (the globally accepted maximum limit being 1.6 W/kg).
User Instructions:
This equipment has very low levels of RF energy and is deemed to be compliant without testing of the specific
absorption rate (SAR). This apparatus is Hearing Aid Compatible (HAC).
Acoustic shock protection
The acoustic level of the signal generated by the handset earpiece is less than 130 dBspl for a transient signal (123
dBspl for Australia) and less than 118 dBspl (rms) for a continuous signal (120 dBA for Australia).
To Next Page
Loading...
