Alcatel-Lucent 8232 DECT User Manual

8232 DECT Handset
8AL90861USACed01
42 /56
8 Registering the telephone
8.1 Registering the telephone on a system for the first time
For the mobile telephone to function, it must be registered on at least one ALE International or GAP system
(registration operation).If when first switched on the display indicates: 'System 1 Auto install ?' your telephone has not
been registered on any system
 Auto install?
 Confirm.
Registration can begin.
A- If the system does not use an AC code.
 Launch subscription.
B- If the system uses an AC (authentication code).
 Register
 Enter the PIN Code (The default is 0000).
 Apply.
 Select a system (It is recommended that the first empty system is selected).
 Apply.
 Enter PARK code (enter nothing if not mandatory).
 Apply.
 Enter access code (enter nothing if not mandatory).
 Apply
 Select Power mode (You are advised not to select the 50 mW power mode unless required. The
'50mW power mode' is intended for hazardous sites such as nuclear plants where it is requested that
emissions do not exceed the maximum value.).
 Legacy Mode:
 Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
The registration operation can last up to 2 minutes.
 If the operation has been done correctly (subscription accepted), the telephone is ready to be used and the radio
reception quality icon is displayed.
 If the registration operation has not been successful, the station proposes launching the subscription again.
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will be considered
under the terms of the warranty.

Alcatel-Lucent 8232 DECT Specifications

General

Brand	Alcatel-Lucent
Model	8232 DECT
Category	Telephone Accessories
Language	English