H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 31 /111
◼ Ending one call
The user may hang up the current call by pressing the [More] and then the [End] button. The device will
return to single call mode in hold status. The user can then press the [Resume] button to resume the call.
8.3 End of the call
After the user finishes talking, the user can put the handset back on the telephone, and then press the
hands-free button or soft key [End] to close the voice channel and end the call.
Note: When the telephone is in “Hold” status, the user must press the [Resume] key to return to
communication status, and then put the handset back or press the hands-free button to end the call.
8.4 Redialing
⚫ Redialing the last outgoing number:
When the telephone is in standby mode, press the redial button and the telephone will call out the last
outgoing number.
⚫ Call out any number with the redial key:
Enter the number, press the redial key, and the telephone will call out the number on the dial.
⚫ Press the redial key to enter the call record:
Log in to the telephone page, enter [Phone Settings] >> [Features] >> [Redial Settings], check
Redial Enter Call Log. Press the redial button when in standby to enter the Call Log page, and press
again to call out using the current located number.
Figure 20 - Redial set
To Next Page
Loading...
