Alcatel-Lucent H2P DeskPhone - Telephone Settings >> Media Settings

H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 94 /111
12.8 Telephone settings >> Media settings
Change voice settings.
Table 23 - Voice Settings
Parameters
Description
Codecs Settings
Select enable or disable voice encoding:
G.711A/U, G.722, G.729, G.726-16, G726-24, G726-32, G.726-40,
ILBC, Opus
Audio Settings
Handset Volume
Set the handset volume. The value must be 1~9
Default Ring Type
Configures default ring tones. If no special ring tone is set for the
telephone number, the default ring tone will be used.
Speakerphone Volume
Sets the hands-free volume to 1-9.
Headset Ring Volume
Sets the volume of the earphone ring tone to 1~9.
Headset Volume
Sets the volume of the headset to 1~9.
Speakerphone Ring Volume
Sets the volume of hands-free ring tone to 1~9.
G.723.1 Bit Rate
5.3kb/s or 6.3kb/s is available.
DTMF Payload Type
Enters the DTMF payload type. The value must be 96~127.
AMR Payload Type
Sets AMR load type, range 96~127.
Headset Mic Gain
Sets the earphone's radio volume gain to fit different models of
earphones.
Opus payload type
Sets Opus load type, range 96~127.
OPUS Sample Rate
Sets Opus sampling rate, including opus-nb (8KHz) and opus-wb
(16KHz).
ILBC Payload Type
Sets the ILBC payload type. The value must be 96~127.
ILBC Payload Length
Sets the ILBC payload length
Enable MWI Tone
When there is a new voice message, the telephone will start a special
dial tone.
Enable VAD
Determines whether voice activity detection is enabled.
Onhook Time
Configures a minimum response time. Default is 200ms.
EHS Type
EHS headset is available after enabling.
RTP Control Protocol(RTCP) Settings
CNAME user
Sets CNAME user
CNAME host
Sets CNAME host
RTP Settings
RTP keep alive
Holds the call and sends the packet after 30 seconds.
Alert Info Ring Settings