H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 39 /111
8.13 Conference
8.13.1 Local conference
To conduct a local conference, the user needs to log in to the webpage and enter [Line] >> [SIP] >> [Basic
settings]. The Meeting mode is set as local (the default is local mode), as shown in the figure:
Figure 39 - Local conference setting
Two ways to create a local conference:
1） The device has two channels of communication. Press the conference button on the call interface.
When selecting the conference number, select the other number that already exists. Press the OK
key to start the conference.
→ →
Figure 40 - Local conference (1)
2） If the device has a call all the way, press the conference key in the call interface, enter the number
to join the meeting, and press the call. After the other end has answered, press the conference
button again to set up the local tripartite conference：
→ →
Figure 41 - Local conference (2)
Note: During the conference, press the split button to split the conference and press the end button to end
the call.
To Next Page
Loading...
