H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 60 /111
10.1.3.2 Screen saver
⚫ Press [Screen Settings] to find the [Screen protection] button, press the [left] / [right] button to
open/close the screen protection, and set the timeout time. The default is 15 seconds. After completion,
press the [OK] button to save.
⚫ After saving, return to standby mode and enter the screen saver after 15 seconds, as follows:
Figure 80 - Telephone screen saver
10.1.4 Ring
When the device is in the default standby mode,
⚫ Press [Setting] >> [Phone] >> [Ringing].
⚫ Press the left / right navigator keys to adjust the ring volume of [Headset] or [Handsfree].
⚫ Press the left / right navigator keys to adjust [Ring type].
⚫ Save the adjustment by pressing [OK].
Figure 81 – Setting the telephone ring
⚫ You can also press key or to adjust the ring volume.
10.1.5 Voice volume
When the device is in a call,
⚫ Press the or key to adjust the voice volume.
Figure 82 – Setting the voice volume
10.1.6 Greeting words
Web interface:
⚫ Go to [Phone Settings] >> [Advanced], edit [Greeting Words], and press [Apply] to save.
⚫ Go to [Phone Settings] >> [Features] >> [Basic Settings], uncheck [Enable Default Line], and press
[Apply] to save.
NOTE: The welcome message can only be displayed in the upper left corner in standby mode when
the Enable Default Line option is disabled.
To Next Page
Loading...
