H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 95 /111
Sets the value to specify the ring type.
12.9 Telephone settings >> MCAST
This feature allows the user to make some kind of broadcast call to people who are in a multicast group.
Users can configure a multicast DSS Key on the telephone, which allows users to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address without involving SIP signaling.
You can also configure the telephone to receive an RTP stream from a pre-configured multicast listening
address without involving SIP signaling. You can specify up to 10 multicast listening addresses.
Table 24 - Multicast Parameters
Defines the priority of the active call. 1 is the highest priority, 10 is the lowest.
The voice call in progress takes precedence over all incoming paging calls.
Server name of multicast being listened to.
Server multicast IP address and port of the multicast being listened to.
12.10 Telephone settings >> Action
Action URL
Note: Action urls are used for IPPBX systems to submit telephone events. Please refer to
manufacturer Action URL for details.
12.11 Telephone settings >> Time/Date
The user can configure the time settings of the telephone on this page.
Table 25 - Time&Date Settings
Network Time Server Settings
Time Synchronized via SNTP
Enables time-sync through SNTP protocol.
Time Synchronized via DHCP
Enables time-sync through DHCP protocol.
Sets primary time server address.
Sets secondary time server address when primary server is not
reachable. The device will try to connect to secondary time server to
get time synchronization.
Time of re-synchronization with time server.
Sets the time display in 12-hour mode.
To Next Page
Loading...
