H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 54 /111
Figure 69 – Setting the BroadSoft server
Note: If the server you are using is not a BroadSoft server, you do not need to select a server type.
⚫ If you need to enable the SCA function on an IP telephone, log in to the web page of the telephone set,
choose [Line] >> [SIP] >> [Advanced Settings], and select Enable SCA. If SCA is not enabled, the
registered line is the private line.
Figure 70 - Enabling SCA
After an account is configured and successfully registered, you can configure lines whose DSS Key is Shared
Call Appearance on the Function Key page to facilitate viewing the call status of the group. Each line key
represents a call appearance. Learn about call status by referring to 6.3 Appendix III –LED .
To facilitate private holding, configure keys whose DSS Key is Private Hold on the Function Key page. Pay
attention that the public hold key is the softkey-hold key during a call.
To Next Page
Loading...
