Alcatel-Lucent H2P DeskPhone - Page 83

H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 83 /111
Disable Call Forward on
Busy
Sets the feature code to dial to the server.
Enable Call Forward on
No Answer
Sets the feature code to dial to the server.
Disable Call Forward on
No Answer
Sets the feature code to dial to the server.
Enable Blocking
Anonymous Call
Sets the feature code to dial to the server.
Disable Blocking
Anonymous Call
Sets the feature code to dial to the server.
Call Waiting On Code
Sets the feature code to dial to the server.
Call Waiting Off Code
Sets the feature code to dial to the server.
Send Anonymous On
Code
Sets the feature code to dial to the server.
Send Anonymous Off
Code
Sets the feature code to dial to the server.
SIP Encryption
Enables SIP encryption so that SIP transmission will be encrypted.
RTP Encryption
Enables RTP encryption so that RTP transmission will be encrypted.
Enable Session Timer
Sets the line to enable call ending by session timer refreshment. The call
session will be ended if there is not a new session timer event update
received after the timeout period.
Session Timeout
Set the session timer timeout period.
Enable BLF List
Enable/Disable BLF List
BLF List Number
BLF List allows one BLF key to monitor the status of a group. Multiple BLF
lists are supported.
Response Single Codec
If setting enabled, the device will use single codec in response to an
incoming call request.
BLF Server
The registered server will receive the subscription package from the ordinary
application of a BLF telephone.
Please enter the BLF server if the sever does not support a subscription
package. The registered server and subscription server will be separated.
Keep Alive Type
Sets the line to use dummy UDP or SIP OPTION packet to keep NAT pinhole
opened.
Keep Alive Interval
Sets the “keep alive” packet transmitting interval
Keep Authentication
Keeps the authentication parameters from previous authentication.
Blocking Anonymous
Call
Rejects any incoming call that does not present a caller ID.
User Agent
Sets the user agent. The default is Model with Software Version.