Chassis and Power Supplies Monitoring Chassis Components
OmniSwitch 6900 Hardware Users Guide June 2020 page 3-61
Monitoring Chassis Components
Viewing Chassis Slot Information
To view basic slot information, enter the show module command at the CLI prompt:
-> show module
To view more detailed information, use the show module long command:
-> show module long
Monitoring Chassis Temperature
The operating temperature of your switch is a critical factor in its overall operability. In order to avoid a
temperature-related system failure, your switch must always run at a temperature within the specified
operating temperature range. Refer to the chassis specifications section for additional information.
To avoid chassis over-temperature conditions, follow the important chassis airflow recommendations
on page 3-33.
To check the switch’s current temperature status, use the show temperature command:
-> show temperature
For more information about this command, see the “Chassis Management and Monitoring Commands”
chapter in the OmniSwitch AOS Release 8 CLI Reference Guide
To Next Page
Loading...
