Alderon Industries™ - Leading Edge Control Products | 13
Mini Power Post™ Monitoring System - USER GUIDE
Pump Run and Total Gallons Pumped
PUMP RUN - TOTAL GALLONS PUMPED (TGP)
When the pump is running under normal operating conditions,
the system will record total gallons pumped. This calculation is
based on the gallons per minute (GPM) setting, factory set to
zero. Use the menu keypad to access the information below while
the pump is running or when the system is idle. See pages 21,
23, 24, 27, and 28 for detailed information and display screens.
▪ TGP Stats - Records total gallons pumped. When the
maximum displayed gallons are exceeded, the gallons
will restart at zero (maximum value of 9999999G).
▪ GPM Setting - Use the menu keypad to change the
setting. If the GPM is set to zero, the TGP stats will not
be displayed on the OLED screen. See page 21 for
detailed information.
▪ Manually Calculate GPM Value to Program
i. Measure water level in tank.
ii. Run pump for designated amount of time.
iii. Measure new water level in tank.
iv. Calculate results from test.
▪ All Data Stored in Two Formats
i. Resettable; Reset all data to zero.
ii. Non-Resettable; All lifetime data is stored.
PUMP RUN
When the pump is running under normal operating conditions, the
blue LEDs will illuminate inside the top cover of the enclosure.
The OLED screen will display a PUMP RUN event and the pump
amps are displayed. Use the menu keypad to access the pump run
information below while the pump is running or when the system
is idle. Turn off the blue pump run LEDs in the settings menu. See
pages 21, 23, and 27 for detailed information and display screens.
▪ Pump Run Event Counter - Records each pump event.
▪ Pump Run Elapsed Time - Records the total run time of
each pump run event including: last, average, maximum,
and minimum of the last 10 pump cycles.
▪ Pump Amp Detection - Records the amps each time a
pump event occurs including: last, average, maximum,
and minimum of the last 10 pump cycles.
▪ Pump Float Event Counter - Records each time the
pump float is activated during a pump run event.
▪ Pump Run Settings - Use the menu keypad to change
the factory settings for: pump run LED turn on or off and
gallons per minute. See page 21 for detailed information.
▪ All Data Stored in Two Formats
i. Resettable; Reset all data to zero.
ii. Non-Resettable; All lifetime data is stored.
To Next Page
Loading...
