Chapter 5
Programming Parameters
5–30
Parameter Descriptions A detailed description of each 1336 FORCE Parameter is contained in
the following listing. The parameters are listed in numerical order.
Take note that some parameters are used more than once in the 1336
FORCE, and may be located in more than one File and Group. To
determine if a parameter is used in more than one application, refer to the
numerical list which begins on Page 5-3.
NOTE: The following parameter descriptions in the range from 300 to
500 cover the Standard Adapter Only! If you have a PLC Comm
Adapter equipped drive, and wish to refer to PLC Comm parameter
descriptions, refer to the PLC Comm User Manual. If you have a
ControlNet Adapter equipped drive, parameter descriptions are provided
at the end of this chapter.
NOTE: If you wish to record parameter values and links that have been
set for your particular application, a User Parameter Sheet is provided in
Appendix C.
To Next Page
Loading...
Need help?
General
