Allen-Bradley 1336 FORCE - Page 193

Chapter 5
Programming Parameters
5–67
Testpoint Selection #5
[Torq TP Sel 5]
Parameter Number 281
Parameter Type Sink
Display Units x
Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 100
Testpoint Data #5
[Torq TP Data 5]
Parameter Number 282
Parameter Type Source
Display Units +/– x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value 32767
Testpoint Selection #6
[Torq TP Sel 6]
Parameter Number 283
Parameter Type Sink
Display Units x
Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 100
Testpoint Data #6
[Torq TP Data 6]
Parameter Number 284
Parameter Type Source
Display Units +/– x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value 32767
Selection for Test DAC 1
[Test DAC1 Sel]
Parameter Number 285
Parameter Type
Display Units
Drive Units
Factory Default 1
Minimum Value 0
Maximum Value 256
Selection for Test DAC 2
[Test DAC2 Sel]
Parameter Number 286
Parameter Type
Display Units
Drive Units
Factory Default 4
Minimum Value 0
Maximum Value 256
This parameter is for factory use only! DO
NOT ATTEMPT TO USE.
Ki Frequency Regulator
[Ki Freq Reg]
Parameter Number 287
Parameter Type Sink
Display Units x
Drive Units None
Factory Default 300
Minimum Value 0
Maximum Value 32767
Integral gain of the frequency regulator in
sensorless mode. This parameter must
not be changed.
This parameter selects a torque block test
point. The value of that test point can be
read from Testpoint Data #5 (Parm 282).
This parameter contains the data selected
by Testpoint Selection #5 (param 281).
This parameter selects a torque block test
point. The value of that test point can be
read from Testpoint Data #6 (Parm 284).
This parameter contains the data selected
by Testpoint Selection #6 (param 283).
This parameter is for factory use only! DO
NOT ATTEMPT TO USE.