Publication 1734-UM006B-EN-P - August 2005
Configure Modules in RSLogix 5000 Software A-5
Work with the Counter
Configuration Dialog
Complete entries as follows from the Counter Configuration dialog.
1. For Type, select one of the following, to set the Counter
Configuration mode.
• Counter (default)
• Encoder X1, Encoder X2, or Encoder X4
• Period/Rate
• Rate Measurement
2. Refer to the table to see what entries to complete based on what
you enter for Type.
Complete This Entry If You Select This for Type
Counter Encoder
X1, X2, X4
Period/
Rate
Rate
Measurement
Store Count Mode X X
Rollover X X
Counter Attenuator X X
Frequency Precision X X
Time Base/Gate Interval X
Invert Input Z X X X
Scalar X
AB Drives
To Next Page
Loading...
