Allen-Bradley 1794-IF4I - Page 119

Publication 1794-6.5.8 - January 2010
Input, Output, Status and Configuration Files for Analog Modules when used with ControlNet 119
01014-20mA signed 2’s complement % 4% Under, 4% Over <0–10000> <0–10000> 7.5ms
01100–10V signed 2’s complement % 0% Under, 2% Over 0–10000> 0–10000> 5.0ms
0111+
10V signed 2’s complement % 2% Under, 2% Over
<–10000–10000>
<–10000–10000> 5.0ms
10000–20mAbinary 0% Under, 4% Over 0000–F3CF> 0000–62415> 2.5ms
1001
4–20mA
(1)
binary 4% Under, 4% Over 0000–F0F1> 0000–61681> 7.5ms
10100–10V binary 0% Under, 2% Over 0000–F9C2> 0000–62415> 2.5ms
10110–5V binary 0% Under, 4% Over 0000–F3CF> 0000–62415> 2.5ms
1100+
20mA offset binary, 8000H = 0mA 4% Under, 4% Over <0618–F9E8> <32768–63976> 2.5ms
11014–20mAoffset binary, 8000H = 4mA4% Under, 4% Over <8000–F878> <32768–63608> 7.5ms
1110+
10V offset binary, 8000H = 0V 2% Under, 2% Over <031F–FCE1> <1560–63976> 2.5ms
1111+5V offset binary, 8000H = 0V 4% Under, 4% Over <0618–F9E8> <1560–63976> 2.5ms
(1)
Underrange for 4-20mA occurs in the blind area below 0 (3.2mA).
Table 6.9
Configuring Your Input Channels
Table 6.10
Setting the Input Filter
Bits Channel
03 02 01 00 Input Channel 0
07 06 05 04 Input Channel 1
A/D Conversion
Rate
Low Pass Filter
00001200Hz No low pass
00011200Hz 100ms low pass
00101200Hz 500ms low pass
00111200Hz 1000ms low pass
0100600Hz No low pass
0101600Hz 100ms low pass
0110600Hz 500ms low pass
0111600Hz 1000ms low pass
1000300Hz No low pass
1001300Hz 100ms low pass
1010300Hz 500ms low pass
1011300Hz 1000ms low pass
1100150Hz No low pass
1101150Hz 100ms low pass
1110150Hz 500ms low pass
1111150Hz 1000ms low pass