Publication 1794-6.5.8 - January 2010
Preface 4
Common Techniques Used
in this Manual
The following conventions are used throughout this manual:
• Bulleted lists such as this one provide information, not
procedural steps.
• Numbered lists provide sequential steps or hierarchical
information.
For Additional Information
For additional information on FLEX I/O systems and modules, refer to
the following documents:
Chapter 4 Writing Configuration to and
Reading Status from Your
Module with a Remote I/O
Adapter
Explains how to configure
your modules and read
status information from your
modules when using a
remote I/O adapter
Chapter 5 Communication and I/O
Image Table Mapping with
the DeviceNet/ControlNet
Adapter
Explains how you
communicate with your
modules, and how the I/O
image is mapped when
using a DeviceNet adapter
Chapter 6 Input, Output, Status and
Configuration Files for
Analog Modules when used
with ControlNet
Explains how you
communicate with your
modules over ControlNet.
Chapter 7 Calibrating Your Module Explains how to calibrate
your module.
Appendix A Specifications Specifications for the
isolated analog modules
Appendix B Class I, Division 2, Group A,
B, C, D Hazardous Locations
Statement
Hazardous location approval
Section Title Contents
Catalog Numbers Voltage Description Publications
Installation
Instructions
User Manual
1794 1794 FLEX I/O Product Data 1794-2.1
1794-ACN 24V dc ControlNet Adapter 1794-5.8
1794-ACNR 24V dc Redundant Media ControlNet Adapter 1794-5.18
1794-ADN 24V dc DeviceNet Adapter 1794-5.14 1794-6.5.5
1794-ASB/C 24V dc Remote I/O Adapter 1794-5.46 1794-6.5.9
To Next Page
Loading...
