Rockwell Automation Publication 825-UM004D-EN-P - November 2012 39
Front Panel Operation Chapter 3
9. If the password is incorrect, the relay displays the message Invalid
Password.
10. Press the Enter push button to return to your previous task.
To Correct Entry Errors
To correct password entries, do the following:
1. If the cursor in the upper line of the display is blinking, press the Esc push
bu
tton once.
2. Use the arrow push buttons to move the underline cursor to the position
of t
he incorrect letter.
3. With the incorrect letter underlined, press the DownArrow push button.
The bl
inking cursor reappears in the upper line of the display and the
underline cursor appears in the lower line.
• Add New Character.
To substitute a new character in the location of
the blinking cursor, use arrow push buttons to move the underline
cursor to the location of the character that you want in the character
table; then press Enter.
• D
elete Character. To
delete the character at the blinking cursor, use the
arrow push buttons to move the underline cursor to Del and press the
Enter push button.
• Clear P
assword. T
o clear the entire password and start over, use the
arrow push buttons to move the underline cursor to Clr and press the
Enter push button.
4. Con
tinue making corrections until the password appears in the upper line
of th
e display.
5. With the correct Access Level 2 password visible in the upper line of the
di
splay, use the arrows to move the underline cursor to ACCEPT.
6. P
ress the Enter push button to accept the password shown in the upper
li
ne of the display.
7. If the password is correct, the relay continues the task.
8. Press enter to continue your task. If the password was incorrect, the relay
di
splays the message
Invalid Password.
9. Press the Enter push button to return to your password entry.
10. Repeat Steps 1…9 until you enter the correct password.
11. When you have completed changing settings, use the Main Menu
co
mmand Reset Access Lvl (described in the next section) to reset the
Access Level to Level 1 so that unauthorized access is prevented. (The
access level will remain at Level 2 until the front panel backlight times
out or the Reset Access Lvl command is executed.)
To Next Page
Loading...
Need help?
General