Allen-Bradley ControlLogix 1756 - Specifying CONFIG Attributes

Publication 1756-RM084F-EN-P - July 2002
3-36 Creating a Complete Import/Export File
Specifying CONFIG attributes
The attributes depend on the type on CONFIG object you specify.
Some objects do not have any attributes. The following table lists
those objects that have attributes and descriptions of each:
Object: Attribute: Description:
ASCII XONXOFFEnable
Specify whether to regulate the flow of incoming data. Enter 0 to
disable XON/XOFF; enter 1 to enable XON/XOFF.
Specify:
XONXOFFEnable := value
DeleteMode
Specify the delete mode. Enter 0 for Ignore; enter 1 for CRT; or
enter 2 for Printer.
Specify:
DeleteMode := value
EchoMode
Specify whether to echo data back to the device from which it was
sent. Enter 0 to disable; enter 1 to enable.
Specify:
EchoMode := value
TerminationChars
Specify the characters that designate the end of a line.
Specify:
TerminationChars := value
AppendChars
Specify the characters to append to the end of a line.
Specify:
AppendChars := value
BufferSize
Specify the maximum size of the data array (1-65535 bytes) that you
plan to send and receive.
Specify:
BufferSize := value
ControllerDevice
none none
CST SystemTimeMasterID
Specify whether the controller is the coordinated system time
master. Enter 16#0000 is the controller is not the CST master; enter
16#0001 if the controller is the CST master.
Specify:
CST := 16#value
DF1 DuplicateDetection
Specify whether to enable duplicate message detection, which
ignores duplicate messages. Enter 0 to disable; enter 1 to enable.
Specify:
DuplicateDetection := value
ErrorDetection
Specify the error detection method. Enter BCC Error or CRC Error.
Specify:
ErrorDetection := text
EnbeddedResponseEnable
Specify the response method. Enter 0 to autodetect; enter 1
to enable.
Specify:
EnbeddedResponseEnable := value
DF1Mode
Specify the DF1 mode. Enter Pt to Pt, Master, or Slave.
Specify:
DF1Mode := value
ACKTimeout
Specify the time to wait for an acknowledgment to a message
transmission. Enter an increment of 20ms (0-65535).
Specify:
ACKTimeout := value
NAKReceiveLimit
Specify the number of NAKS (0-255) the controller can receive in
response to a message before stopping transmission.
Specify:
NAKReceiveLimit := value
ENQTransmit
Specify the number of inquiries (0-127) you want the controller to
send after an ACK timeout.
Specify:
ENQTransmit := value