Allen-Bradley ControlLogix 1756 - Page 58

Publication 1756-RM084F-EN-P - July 2002
3-38 Creating a Complete Import/Export File
SerialPort BaudRate
Specify the communication rate for the serial port. Enter 110, 300
600, 1200, 2400, 4800, 9600, 19200, or 38400
Specify:
BaudRate := value
Parity
Specify the parity setting for the serial port. Parity provides
additional message-packet error detection. Enter None Parity, Even
Parity, or Odd Parity.
Specify:
Parity := text
DataBits
Specify the number of bits per message packet. Enter 0 7 Data Bits
or 8 Data Bits.
Specify:
DataBits := text
StopBits
Specify the number of stop bits to the device with which the
controller is communicating. Enter 1 Stop Bit or 2 Stop Bit.
Specify:
StopBits := text
ComDriverId
Specify the type of serial driver. Enter DF1.
Specify:
ComDriverId := text
PendingComDriverId
Specify type of serial driver. Enter DF1.
Specify:
PendingComDriverId := text
RTSOffDelay
Specify a time delay to make sure the modem successfully
transmits the entire message. Enter an increment of 20ms
(0-32767). Normally leave at zero.
Specify:
RTSOffDelay := value
RTSSendDelay
Specify a time delay to let the modem prepare to transmit a
message. Enter an increment of 20ms (0-32767).
Specify:
RTSSendDelay := value
ControlLine
Specify the mode in which the serial driver operates. Enter No
Handshake, Full Duplex, Half Duplex without Continuous Carrier, or
Half Duplex with Continuous Carrier.
Specify:
ControlLine := text
PendingControlLine
Specify the mode in which the serial driver operates. Enter No
Handshake, Full Duplex, Half Duplex without Continuous Carrier, or
Half Duplex with Continuous Carrier.
Specify:
PendingControlLine := text
RemoteModeChangeFlag
Specify whether there is a remote change. Enter 0 or 1.
Specify:
RemoteModeChangeFlag := value
PendingRemoteModeChange
Flag
Specify whether there is a remote change. Enter 0 or 1.
Specify:
PendingRemoteModeChangeFlag := value
ModeChangeAttentionChar
Specify the mode change attention character.
Specify:
ModeChangeAttentionChar := value
PendingModeChange
AttentionChar
Specify the mode change attention character.
Specify:
PendingModeChangeAttentionChar := value
Object: Attribute: Description: