Rockwell Automation Publication 2094-UM002G-EN-P - August 2016 153
Configure and Start the Kinetix 6200 Drive System Chapter 6
The New Module dialog box opens.
4. Configure the new module.
a. Type the module Name.
b. Enter the Node address.
Set the node address in the software to match the node setting on the
drive. Refer to Configure the Drive Modules, step 2
, on page 142.
c. Check Open Module Properties.
5. Click OK.
6. Click the Associated Axes tab.
7. Click New Axis.
The New Tag dialog box opens.
To Next Page
Loading...
