78 Rockwell Automation Publication 2711P-UM006E-EN-P - January 2017
Chapter 3 Configuration Mode
Display FactoryTalk View ME Station Information
You can display the firmware and version information for installed system
components on your terminal and technical support information.
1. Press Terminal Settings>System Information>About FactoryTalk View
ME Station.
2. Press Technical Support to display the support phone number and website
for your terminal.
3. Press Close until you return to terminal settings.
Enable or Disable the Alarm
Display
Each new alarm that occurs on the terminal is displayed in the alarm display or
banner. When the newest alarm is acknowledged by the operator, you can choose
to close the alarm display or leave it open. By default the alarm display is closed.
1. Press Terminal Settings>Alarms.
2. Press Yes or No:
• Yes, the default option, closes the alarm display each time the operator
acknowledges the newest alarm.
• No leaves the alarm display open after the operator acknowledges the
newest alarm.
3. Press OK.
To Next Page
Loading...
Need help?
General
