Allied Telesis GS910 Series - Key Features

GS910 Series Gigabit Ehternet Unmanaged Switch Installation and User’s Guide
20
Key Features
The GS910 series switches have the following key features:
 10/100/1000 Mbps twisted pair ports with RJ-45 connectors
 IEEE802.3 compliant for 10Base-T
 IEEE802.3u compliant for 100Base-TX
 IEEE802.3ab compliant for 1000Base-T
 Auto-Negotiation (IEEE 802.3u-compliant) on all ports
 Auto MDI/MDI-X on all ports
 Store-and-forward switching method
 IEEE 802.3x flow control for full-duplex operation
 Back pressure flow control for half-duplex operation
 Head-of-line blocking
 Jumbo frames of 9216 bytes without frame loss for the
AT-GS910/5, AT-GS910/5E, AT-GS910/8 and AT-GS910/8E
switches
 Jumbo frames of 10K bytes without frame loss for the
AT-GS910/16 and AT-GS910/24 switches
 Storage of up to 2K MAC addresses for the AT-GS910/5 and
AT-GS910/5E switches
 Storage of up to 4K MAC addresses for the AT-GS910/8 and
AT-GS910/8E switches
 Storage of up to 8K MAC addresses for the AT-GS910/16 and
AT-GS910/24 switches
 BPDU protection from passing through
 EAPOL pass-through
 Power saving
 Loop Prevention that is enabled or disabled from the DIP switch on
the front panel
 IEEE 802.3az Energy Efficient Ethernet that is enabled or disabled
from the DIP switch on the front panel
 Diagnostic LEDs
 RoHS compliant
 12VDC locking power connector for the AT-GS910/5E and
AT-GS910/8E switches