Chapter 4: Installation Using the AT-RKMT-J08 Rack Mount Kit
59
Unpacking the AT-RKMT-J08 Rack Mount Kit
To unpack the AT-RKMT-J08 rack mount kit, perform the following
procedure:
1. Remove all components from the shipping package.
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Verify that all hardware components are included in your rack mount
package listed in Table 10.
Table 10. Components in the AT-RKMT-J08 Rack Mount Kit
Components
Two Short Brackets
Two Handles
Two Cable Brackets
Two Long Brackets
Eight M3x6mm
screws
To Next Page
Loading...
