Chapter 2: Installation
31
All Countries: Install product in accordance with local and National
Electrical Codes. E8
The power input must be provided from SELV source only, per IEC
60950. Do not connect to a centralized DC battery bank. E31
An insecurely attached device on a wall may fall and the falling
device may lead to damaging itself or causing injuries. E96
Do not install the device on an unstable wall or a wall affected by
vibration or impact. The device may fall and falling device may lead
to damaging itself or causing injuries. E97
Do not install the device high on a wall. The device may fall and the
falling device may lead to damaging itself or causing injuries. E98
Disconnecting the Device: If the device becomes damaged or you
encounter abnormality with the device, disconnect the power plug
from the AC wall outlet immediately. E100
Use appropriate screws to attach the device and brackets to a
19-inch rack. If a device is installed insecurely in a rack, it may fall,
potentially causing injuries or damage to the device. E104
To Next Page
Loading...
Need help?
General
