GS910 Series Gigabit Ehternet Unmanaged Switch Installation and User’s Guide
38
To install the AT-GS910/24 switch on the wall, you must install the
switch with the rear panel facing to the left in order for the switch to
have proper air flow.
Mounting the front panel facing up or down on the wall is incorrect
for the AT-GS910/5, AT-GS910/8, AT-GS910/8E, AT-GS910/16,
and AT-GS910/24 switches. See Figure 17 as examples.
Figure 17. Incorrect Wall Installation
An insecurely attached device on a wall may fall and the falling
device may lead to damaging itself or causing injuries. E96
Do not install the device on an unstable wall or a wall affected by
vibration or impact. The device may fall and falling device may lead
to damaging itself or causing injuries. E97
Do not install the device high on a wall. The device may fall and the
falling device may lead to damaging itself or causing injuries. E98
Installing the device on a wall may damage the wall paint.