Altana BYK wave-scan 3 User Manual

BYK-Gardner GmbH Standard Measurements | 5
301 200 085 E 2309 wave-scan 3 / wave-scan 3 dual 29
5 Standard Measurements
This function allows to perform various test series with different samples and vari-
able number of measurements. The results are stored automatically. If more than
one measurement is done on a sample, statistics are evaluated. Make sure the pa-
rameters are set: see: Measurement Parameters [}47].
Prerequisite: You are familiar with the Quick Measurements [}25] mode.
NOTICE
Standards can be created in the instruments and can be downloaded from “smart-
chart”. Downloaded standards cannot be deleted in the instrument, but only via
the software.
5.1 Overview
You are able to manage your measurements as shown in the following example.
Standard 001
--- Test series 001
--- --- Sample 001
--- --- --- Measurement 1
--- --- --- Measurement 2
--- --- --- …
--- --- --- Measurement n
--- --- Sample 002
--- --- …
--- --- Sample n
--- Test series 002
--- …
--- Test series n
…
Standard 2
…
Standard n
The objects listed above are to be administrated in the following way:
• Standard: Contains different Test series. Create and fill in Measure mode.
Renaming is not supported. View and delete in Browse mode – only if filled
with data.
• Test series: Contains different Samples. Create and rename in Measure
mode. Delete in Measure mode or in Browse mode. View in Browse mode.
• Sample: Contains different Measurements. Create and rename in Measure
mode. Delete in Measure mode. View in Browse mode. Number of Mea-
surements see Configuration > Measurement Parameters > Statistics.
• Measurement: Contains different measurements data. Create and rename
in Measure mode. Delete in Measure mode. View in Browse mode. Data
displayed see Configuration > Measurement Parameters > Scales.

Altana BYK wave-scan 3 Specifications

General

Brand	Altana
Model	BYK wave-scan 3
Category	Measuring Instruments
Language	English