EasyManuals Logo

Altana BYK wave-scan 3 User Manual

Altana BYK wave-scan 3
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
BYK-Gardner GmbH Introduction | 1
301 200 085 E 2309 wave-scan 3 / wave-scan 3 dual 7
WARNING: Safety advices for rechargeable battery packs
Do not crush or dismantle, do not heat, or incinerate, do not immerse in any liq-
uid, do not place in or near high temperature places or in direct sunlight. Batteries
can explode or release harmful substances.
Ensure batteries have no short circuit on the contacts (for example due to dam-
aged insulation). Metallic objects must not come in contact with the bare contacts.
Immediately discontinue use if batteries appear abnormal in any way.
Use only the battery pack included with delivery. Use only the power supply in-
cluded with delivery. Do not use battery pack or power supply for other devices.
WARNING: Do not try to repair your instrument on your own
Do not perform any repairs on the instrument. The measurement unit must be
opened by BYK-Gardner authorized repair locations only.
Devices returned to BYK-Gardner for repairs or service / recertification must be
shipped without battery pack in the case / instrument.
WARNING: Eye damage caused by illumination LEDs
Looking into the illumination LEDs during measurement could harm your eyes. Do
not look into the measurement aperture when the instrument is turned on - even
if you assume a fault with the instrument.
The instrument is a class 1 laser product. To indicate the risks following label is
placed on the housing and / or on the base of the instrument.
WARNING: Severe material damage
The instrument consists of sensitive optical and electronic precision parts. Prevent it
from being dropped, bumped, or shaken!
Avoid exposure to continuous humidity and condensation. Avoid splashing with
water, chemicals, or other liquids.
Please use only accessories that are available for the unit.
Only devices meeting the requirements for low voltage safety may be connected to
the USB interface.
The charger in the docking station is only to be used to charge the battery packs
delivered with the instrument.

Table of Contents

Other manuals for Altana BYK wave-scan 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Altana BYK wave-scan 3 and is the answer not in the manual?

Altana BYK wave-scan 3 Specifications

General IconGeneral
BrandAltana
ModelBYK wave-scan 3
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals