Amada Vipros 357 Queen - Fanuc 18 PC Controller Specifications; Hydraulic Systems Specifications

Vipros 357 Queen with Fanuc 18PC User Pre-installation Guide ©Amada America, Inc.
Print Date 01/24/2001 Revision 4.0 This document available on the World Wide Web at http://www.amada.com Page 9 of 37
Specifications - Fanuc 18PC Controller
Model Fanuc 18PC (with PHNC)
Control Function X, Y, T & C
Input Method MDI, 3½” Floppy, DNC
Minimum Command Unit 0.001" (X, Y) .01
0
(C)
Minimum Travel Unit 0.001" (X, Y) .01
0
(C)
Operating Modes Automatic, MDI & Manual
Display Modes Program Contents, Position Information, Program Check, Parameters, Tool Hit Counter, Self
Diagnostics
Interlock Displays Oil Temperature, Oil Pressure, Door Open
Specifications - Hydraulic Systems
Power Hydraulic Numerical Control
Ram Cycle Patterns 65 Total
Punching 2
Nibbling 1
Forming 50
Marking 4
Knockouts 4
Slitting 4
Minimum Increment 0.01mm
Hydraulic Power Unit
Model Yuken
Dual Operating Pressure 100 kgf cm² & 195 kgf cm²
Oil Type Mobil DTE
®
Excel 46 (formerly called Mobil Hydraulic Oil NZ 46)
Oil Capacity 40 Gallons