Vipros 357 Queen with Fanuc 18PC User Pre-installation Guide ©Amada America, Inc.
Print Date 01/24/2001 Revision 4.0 This document available on the World Wide Web at http://www.amada.com Page 31 of 37
Y AXIS BALL SCREW
X AXIS BALL SCREW
Y AXIS LM GUIDES
1 EACH SIDE
X AXIS LM GUIDES
TOP AND BOTTOM
UPPER AND LOWER TURRETS
Removing the Protective Coating
The Vipros 357 Queen must be thoroughly cleaned of protective coating. The sheet metal guards can be removed from around
the turret to allow cleaning of the upper and lower turrets, tool bores and die holders.
Please note the following:
! Remove wrapping paper from the X and Y-
axes ball screws, then remove the protective
coating.
! Remove the wrapping paper from the X and Y
LM guides then remove the protective coating,
make sure that you remove the paper from
both sides of the carriage.
! Clean die holders one at a time. Remove a
die holder, clean and replace it before
removing the next die holder. If the die
holders are mixed up, serious turret alignment
problems may occur.
! A suitable solvent should be used to remove
the protective coating.
To Next Page
Loading...
