Amazone AMATRON+ ZA-M - ZA-M Comfort; Procedure for Use

Use on the field
Amatron+ BAG0063.1 03.10 53
6.4 ZA-M Comfort
6.4.1 Procedure for use
1. Use tractor control 1 to supply the control block with hydraulic
fluid.
2.
Switch on the AMATRON
+
.
3.
Select the work menu.
4. Set the power take-off speed (see setting chart).
5. Move off and open both slide gates
6.
In the case of the weighing spreader
 start with a calibration travel
Or:
 carry our online calibration (switch on in Machine data
menu).
7. Once boundary spreading has started:
switch on Limiter
 During spreading, the AMATRON
+
shows the work menu. All the
settings required for spreading should be made here.
 The data determined are stored for the started job.
After use:
1. Close both slide gates.
2. Switch off power take-off.
3. Use tractor controller 1 to stop the hydraulic fluid supply to the
control block.
4.
Switch off AMATRON
+
.