Amazone AMATRON+ ZA-M - Calibration of Slug Pellets

Commissioning
34 Amatron+ BAG0063.1 03.10
5.5.4 Calibration of slug pellets
CAUTION
Before spreading slug pellets, be
sure to check the spreading quan-
tity for both outlets in turn.
To spread slug pellets, go to Machine data menu
page 3 :
1.
Switch on slug pellets
(Fig. 39).
 Calibrate slug pellets for left
outlet:
2. Add a sufficient quantity of slug pellets to
the hopper.
3. Remove both spreader discs.
4. Place collection bucket under the left outlet.
5. Select Main menu to go to the Cali-
brate slug pellets menu.
Fig. 39
Fig. 40
6.
Check/enter the working width.
7.
Check/enter the target quantity.
8.
Check/enter the intended speed.
9. Take the required slider setting for the en-
tered value from the settings chart.
Fig. 41