Amazone AMATRON+ ZA-M - ZA-M Hydro; Procedure for Use

Use on the field
56 Amatron+ BAG0063.1 03.10
6.5 ZA-M Hydro
6.5.1 Procedure for use
1. Use tractor control 1 to supply the control block with hydraulic
fluid.
2.
Switch on the AMATRON+.
3.
Select the work menu.
4.
Switch on spreader discs.
5 Move off and open the slide gates
6.
In the case of the weighing spreader
 start with a calibration travel
Or:
 carry our online calibration (switch on in Machine data
menu).
7. If starting with boundary, trench or side spreading:
, Select type of boundary spreading and edge of
the field (left / right), and switch on.
 During spreading, the AMATRON
+
shows the work menu. All the
settings required for spreading should be made here.
 The data determined are stored for the started job.
After use:
1.
Close the slide gates.
2.
Switch off spreader discs.
3. Use tractor controller 1 to stop the hydraulic fluid supply to the
control block.
4.
Switch off the AMATRON
+
.