Controller / User Interface | 4-35
The typical (default) Measuring Cell temperature measuring range is “A”
(see chart below). Confirm the Cell/Oven RTD Range setting for your
system on the “Analyzer Programming Parameters” sheet (part of the ana-
lyzer Documentation Package).
Measuring Cell Temperature Measuring Range Chart
(JP300, Micro-Interface board)
Temperature
Range Jumper Position Measuring Range
A (default) 1-2 5 °C to 65 °C
Other ranges are available but AMETEK does not recommend chang-
ing the range or the jumpers.
NOTE
To Next Page
Loading...
